Removal of the oil discharge valve.
- The discharge valve (1) is screwed without
any seal in the casing.
- Tightening torque: 4 m.daN.
Removal of the water pump.
- Unscrew the turbine (1) from the drive
shaft (2) while immobilizing it using a 2 mm
diameter drift in (A).
- Remove the circlip (3) located on the bearing
side.
- Drive out the bearing (4) on the timing side by
pushing it out over the pump drive shaft.
- Drive out the mechnical joint (5) from the
turbine side.
- Drive out the seal 6 from the turbine side.
- Drive out the caged needle bearing (7) from
the turbine side.
All the components must be changed every time the pump is serviced..
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
5
1
6
DISASSEMBLY
7
4
2
3
A
23