Removal Of The Rh Crankcase Half - PEUGEOT 125 CC Workshop Manual

DISASSEMBLY

Removal of the RH crankcase half.

- Remove the screw which secures (1) the
chain tensioner slipper (2).
- Remove the chain tensioner slipper.
- Tightening torque: 1 m.daN.
- Remove the timing chain and notice its
direction of rotation.
- Remove the 2 bolts that secure the starter
motor (3)
- Remove the starter motor.
- Tightening torque: 1 m.daN.
Note: Check the condition of the starter
motor O-ring.
- Remove the 8 bolts. One of which is located
on the LH casing..
- Remove the RH casing.
- Remove the 2 centring pillars and the paper
gasket.
Note: No tools are necessary to remove the
RH casing, as the bearing is secured
to the cranshaft and conrod ass'y.
- Tightening torque: 1 m.daN.
Check and if necessary clean the water pump
drain hole (A).
22
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
3
A
2