Setting the timing.
Every time you set the timing you must:
- Empty the oil from the engine.
- Remove the RH cover.
- Remove the flywheel magneto rotor.
- Remove the automatic tensioner.
- Fit the locking pin P/N 754033 in the
crankcase gauge hole.
- Rotate the crankshaft until the pin enters the
crankshaft gauging hole.
- Install the camshaft gear (1) on the camshaft.
- Immobilize the camshaft gear using the
adjustable pin wrench P/N 752237.
- Tighten the camshaft gear screw.
- Remove the cylinder head gauging hole plug.
- Insert the pin P/N 754034 into the cylinder
head gauging hole.
- Rotate the camshaft until the pin enters the
camshaft gauging hole.
- Remove the camshaft gear.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
754033
1
754034
35