Fitting The Cylinder; Fitting The Cylinder Head - PEUGEOT 125 CC Workshop Manual

Fitting the cylinder

- Install the cylinder base gasket and the
2 guiding pillars on the crankcase.
- Position the piston ring gap as follows.
1. Top compression ring gap.
2. Compression ring gap.
3. Upper oil control ring gap.
4. Lower oil control ring gap.
Note: Lubricate the cylinder.
- Fit the timing belt through the cylinder timing
well.
- Compress the piston rings and fit them
manually one after the other into the cylinder
barrel.
- Fit the cylinder front screw (beside the oil
temperature switch).
- Install the the chain tensioner slipper (2).
Note: The cylinder skirt is chamfered in
order to fit the piston rings easily.

Fitting the cylinder head.

- Fit the 2 guiding pillars (1) and the metal
gasket (2) on the cylinder.
- Fit the timing chain through the cylinder head
timing well.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
2
2
1
2
1
4
3
1
33