Removal Of The Crankshaft - PEUGEOT 125 CC Workshop Manual

DISASSEMBLY

Removal of the crankshaft.

- Remove the 2 screws which secure the water
inlet pipe (1).
- Remove the water inlet pipe and the O-ring.
- Tightening torque: 1 m.daN.
- Fit the protective cap P/N 69098 to the crank.
- Fit to casing with tool P/N 64706 fitted with
plate P/N 754006.
- Fix the assembly to the casing using
4 bolts (2).
- Tighten the tool centre screw holding the
crank with one hand on the other side until it is
fully extracted.
- Removing the the cranshaft and conrod
assembly.
Note: When the casings are opened, if the
bearings stay on the crank, use tool
P/N 755585 to remove them.
24
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
69098
2
64706
754006
2