Installing The Piston Rings On The Piston; Fitting The Piston - PEUGEOT 125 CC Workshop Manual

REFITTING SPECIFIC COMPONENTS

Installing the piston rings on the piston.

Proceed in the following order in order to install
the oil control rings.
- Install the spring (1) (no special direction).
- Install the 2 piston rings (2) on each side of
the spring by offsetting the gap of each ring
(no special direction).
- Install the compression ring (3) by placing
the"TOP" mark upwards.
- Install the top compression ring (4) by placing
the "0" mark upwards.

Fitting the piston.

- Install the piston with the arrow engraved on
the piston crown, on the timing side.
Note: Lubricate the piston pin.
Note: The circlips must be changed every
time they are removed.
The circlip gaps (1) must face upwards or
downwards, but under no circumstances to the
side.
32
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
4
3
2
1
1