REFITTING SPECIFIC COMPONENTS
REFITTING SPECIFIC COMPONENTS
Installing the crankshaft LH bearing.
- The bearing is positioned into the casing by
means of a press.
- Fit the seal into the casing using the
installation buffer P/N 757990.
Installing the water pump inside the RH
crankcase.
- Fit the caged needle bearing (1) into the
casing on the turbine side using the pin drift
P/N 754009.
- Fit the seal (2) using the drift P/N 754008, the
seal's lips shall be directed towards the caged
needle bearing..
28
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
757990
754009
1
754008
2