Removal Of The Cylinder Head - PEUGEOT 125 CC Workshop Manual

DISASSEMBLY
- Fit protective cap P/N 69098 to the end of the
crank assembly.
- Tighten flywheel extractor P/N 754003 on the
rotor.
- Lock the flywheel extractor and turn the thrust
bolt until the rotor is released.
- Remove the rotor.
- Tightening torque: 7 m.daN.
Note: When re-installing, make sure the
key (1) is properly positioned on the
crankshaft stem as shown in the
figure.

Removal of the cylinder head.

- Remove the spark plug.
- Rotate the engine by hand in the direction of
operation (clockwise) by means of the fixed
plate in order to bring the rocker pads over the
camshaft's cam lobes..
14
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
.
754003
1
69098