Polaris 2008 RZR Service Manual page 93

Table of Contents

Advertisement

28. Before installing the gear / stator housing, replace the seals
in the cover. Install a new water pump seal (N) into the gear
/ stator housing. Use the Water Pump Mechanical Seal
Installer (PA-44995) to properly install the seal to the
correct depth in the cover.
IMPORTANT: Due to seal design and construction,
seals MUST be installed DRY (no lubricant) during
assembly. Use of lubricants (oil, soapy water, etc.)
will not allow the seal to wear-in and seal properly. Do
not touch seal surface or allow seal surface to come
in contact with contaminates during installation.
Thoroughly clean parts, tools and hands before
installation.
NOTE: To remove the water pump seal, the gear/
stator housing must be removed. The water pump
seal cannot be removed or installed with the gear/
stator housing attached to the engine. Shaft damage
will occur.
NOTE: Install the water pump seal (N) with the seal
lip facing out (towards the crankcase). Use of a
hydraulic press is recommended for this procedure.
29. Install a new crankshaft seal (P) into the gear/stator housing
cover. Use the Universal Driver Handle (PU-45543) and
the Main Seal Installer (PA-45483) to seat the crankshaft
seal into place.
PA-45483
PA-44995
O
N
PU-45543
P
NOTE: Install the crankshaft seal (P) with the seal lip
facing out (towards the crankcase).
Seal lip goes towards the crankcase.
30. Once the crankshaft seal is installed into the gear / stator
housing cover, set the direction of the paper lip by sliding
the Main Crankshaft Seal Saver (PA-45658) into the
crankshaft seal from the rubber lipped side to the paper lip
side (Back to Front). Remove the tool.
Important: Set the direction
of the paper lip seal
31. Carefully install the tapered end of the Crankshaft Seal
Protection Tool (PA-45658) through the paper side of the
crankshaft seal (Back to Front). Leave the seal protector
installed in the crankshaft seal. Check the crankshaft seal
lips to verify they have not been rolled or damaged.
PU-45658
ENGINE
P
3
PU-45658
3.53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rzr 800 20082008 ranger rzr

Table of Contents