Polaris 2008 RZR Service Manual page 59

22. Loosen the hose clamp between the throttle body and intake
adaptor.
23. Disconnect the T-MAP and TPS harnesses (see photo).
24. Remove the remaining bolt attaching the airbox to the
frame (see photo).
25. Remove the airbox and throttle body from the vehicle as an
assembly. Take care in not allowing the throttle cable to
bend excessively or kink. Carefully place the assembly on
the floor next to the vehicle. Insert a shop towel into the
Loosen
engine intake adaptor to prevent dirt from entering the
Clamp
engine.
NOTE: Ensure
excessively bent or kinked while removed from the
vehicle.
26. Mark the fuel injector harnesses to identify MAG and PTO
harness connections to aid during reassembly. Disconnect
the fuel injector harnesses.
NOTE: The Bosch harness connector and locking
spring is bonded to the fuel injectors with an epoxy
mix.
connector from the fuel injectors. Damage will occur
to the injector and/or harness if attempting to
separate at that location. Separate the fuel injector
from the vehicle by disconnecting at the end of the
harness as shown.
27. Disconnect the fuel line from the fuel injector rail.
28. Disconnect the shift cable from the transmission bell crank.
throttle cable
DO NOT attempt to disconnect the Bosch
Fuel
Disconnect Here
Injector
Harness
DO NOT
Disconnect Here
Remove
Clip
ENGINE
is not being
3
3.19