Head Lights; Headlight Adjustment; Headlamp Bulb Replacement - Polaris 2008 RZR Service Manual

HEAD LIGHTS

Headlight Adjustment

The headlight beam is adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of the
headlight and make a mark on the wall at the same height.
3. With the machine in Park, start the engine and turn the
headlight switch to on.
4. The most intense part of the headlight beam should be
aimed 8 in. (20 cm) below the mark placed on the wall in
Step 2.
NOTE: Rider weight must be included in the seat
while performing this procedure.
5. Adjust the beam to the desired position by loosening the
adjustment screw (A) and moving the lamp to the
appropriate height.
A
6. Adjust the beam to desired position. Repeat the procedure
to adjust the other headlight.
WARNING
Due to the nature of light utility vehicles and
where they are operated, headlight lenses
become dirty. Frequent washing is necessary to
maintain lighting quality. Riding with poor
lighting can result in severe injury or death.

Headlamp Bulb Replacement

1. Disconnect the headlamp bulb from the wiring harness. Be
sure to pull on the connector, not on the wiring.
2. Turn the lamp counterclockwise to remove it.
3. Insert new bulb. Reinstall the harness assembly into the
headlight assembly.
NOTE: Make sure the tab on the lamp locates
properly in the housing.
ELECTRICAL
10
10.15