Tps Replacement - Polaris 2008 RZR Service Manual

12. If it does not read .528 ± .01 volts, loosen the screw holding
the TPS to the throttle body. Rotate TPS until voltmeter
reads .528 ± .01 volts.
13. Retighten TPS mounting screw, and verify the voltage did
not change. If changed, repeat the previous steps.
STEP 2
Establishing correct flow: Now that the zero offset voltage has
been set, you can now set the throttle body to the correct air flow
value.
1. With the voltmeter still attached to the TPS Tester Harness
(PU-47082), turn in the air flow adjustment screw until the
voltmeter reads .735 ± .01 volts. The throttle body is now
adjusted to the correct flow value.
Turn Air Flow Screw In
PU-47082 Tester
Red Pink
Should Read
.735
.735 Vdc
2. Reconnect the TPS harness lead
3. Reinstall throttle cable on throttle cam and install cover.
Adjust cable freeplay.
Black
Probe
Red
Probe
Black
ELECTRONIC FUEL INJECTION

TPS Replacement

NOTE: The correct position
established and set at the factory. Do not loosen the
TPS or alter the mounting position. If the TPS is
repositioned, replaced or loosened it must be re-
calibrated by performing "TPS Initialization."
1. If the vehicle is completely assembled, remove the exhaust
pipe and exhaust silencer from the vehicle to gain access to
the throttle body and TPS.
2. Disconnect the TPS harness connection (A).
A TPS
3. Remove the retaining screw (B) and replace the sensor.
4. Refer to "TPS Initialization" for setting the TPS voltage.
of the TPS
B
4.29
is
4