Polaris 2008 RZR Service Manual page 58

ENGINE
12. Elevate the rear of the vehicle off the ground using a
suitable ATV lift and remove both rear wheels.
13. Remove all exhaust components from vehicle and engine.
14. Loosen the hose clamp attaching the outlet duct to the PVT
cover. Leave the duct attached to the upper frame support.
Outlet Duct
15. Remove the (8) screws that retain the PVT cover and
remove cover.
16. Remove the high tension leads from the spark plugs and
disconnect the ignition coil harness.
17. Remove the vent lines from the upper bolt-in frame brace
and plug vent lines to prevent fluid leakage during removal.
3.18
18. Remove the (6) fasteners retaining the upper bolt-in frame
19. Remove the upper nut and grommet from the stabilizer bar
PVT Cover
Harness
Connection
20. Remove the (4) fasteners retaining the stabilizer bar and
21. Remove the engine breather hose from the valve cover.
brace and remove it from the vehicle with the ignition coil
and PVT duct attached.
Frame Brace
PVT Duct
linkage on both sides of the vehicle.
bracket and remove the assembly from the vehicle.
Ignition
Coil