USER'S MANUAL - OPERATIONS COMMON TO ALL MODES
PREHEAT MODE
This mode lowers the temperature of the fusing unit and makes the
machine wait in low power consumption state.
Preheat mode will activate when the set duration of time elapses in
waiting status without executing a job.
Compared to Auto Power Shut-Off Timer, the amount of energy saved
is less and the wakeup time is shorter.
In the preheat mode, the [Home Screen] button is lit and the light goes
off for the touch panel and the [Power Save Mode] button.
The touch panel is cleared when it is tapped or the [Home Screen]
button is pressed.
T o s e t p r e h e a t m o d e :
I n " S e t t i n g m o d e " , s e l e c t [ E n e r g y S a v e ] → [ P r e h e a t M o d e S e t t i n g ] .
A message appears 15 seconds before Preheat Mode is entered. To
close the message and continue normal operation, tap [Continue].
The message appears again 15 seconds before the end of the
extension of normal operation time.
If no action is taken within 15 seconds after the message appears, the
machine enters preheat mode.
T o s e t d i s p l a y o f t h e m e s s a g e :
S e t i n [ E n e r g y S a v e ] → [ P o w e r M a n a g e m e n t S e t t i n g ] → [ D i s p l a y
m e s s a g e f o r d e l a y o f e n t r y i n t o P r e h e a t M o d e / A u t o P o w e r S h u t o f f ] i n
" S e t t i n g m o d e ( a d m i n i s t r a t o r s ) " .
file://C:\Files\PM Files\COPIERS\CR3.5\Virgo II\Manuals downloaded from MFP\mx514...
Page 111 of 227
01-012.htm
4/24/2014