GRAPHTEC FC8600 SERIES Setup Manual page 4

Flow of cutting operation
Introduced here as an example is the process for making a sticker by using the Cutting plotter and Marking
fi lm.
1
Create the data to be cut.
2
Set the media on the Cutting plotter.
a Check which point on the Cutting plotter the
paper should be set.
P.1-5
When Stock roller is mounted at front of main unit : Front loading
When Stock roller is mounted at rear of main unit : Rear loading
b Place the media on Stock tray, and set the media.
(*The illustration shows the rear loading as a case.)
P.2-6
<Front loading>
Setting the Push Roller
Fix the push rollers so that they are
positioned above both ends of media
and also grit rollers.
Stock rollers
<Rear loading>
P.2-13
Grit rollers
Push rollers