Installing The Software - GRAPHTEC FCX2000 SERIES Setup Manual

Install the software stored in the attached DVD-ROM into the PC that is used.
This section explains how to install the software when using a Windows 10 (64-bit) operating environment.
Note •
Upon installation, be sure to log in Windows using an account with administrator privileges on your computer.
If you have logged on using a standard user account, an "User Account Control" screen asking you to enter the administrator account
password may appear.
•
Supported OS
This software supports the following OS environments:
Windows 10 (32-bit/64-bit), Windows 8.1 (32-bit/64-bit), Windows 8 (32-bit/64-bit ), Windows 7 (32-bit/64-bit )
(Plotter driver also supports Windows Vista.)
Mac OS X 10.11 to 10.7
(Graphtec Studio also supports Mac OSX 10.6.)
•
When Using Macintosh
Macintosh operating environments are supported by the following software.
Proceed with installation in accordance with your operating environment.
• Graphtec Studio
• Cutting Master 4
When checking the manual in the Macintosh operating environment, open the pertinent manual on the accompanying DVD-ROM in the
following sequence: [Manuals] > [English] > [Manual According to Software].
•
Setup in a Windows operating environment
Launching the Start Menu
After starting up Windows, insert the [USER GUIDE & SOFTWARE DVD] supplied with the FCX2000 into your computer's DVD
drive.
The below screen will appear before the Start Menu launches.
Continue with installation in accordance with the following procedures.
1
The start-up message of DVD drive is displayed. Click on the message.
* When setting up the DVD in the computer, this message will disappear after a few seconds.
2
DVD operation screen is displayed.
Select the "Run MultiSetup.exe" from the DVD operation screen.
* If the DVD operation screen is not displayed, select the set DVD drive from the Explorer.
Then, select the "MultiSetup.exe" in the DVD and double-click on it.

Installing the Software

: Software application that enables cutting data to be created through simple commands.
: Plug-in driver that can be directly operated from within Adobe Illustrator.
Note that Adobe Illustrator must be installed on your computer prior to use.
7