GRAPHTEC FC8600 SERIES Setup Manual page 19

When the media width exceeds 540 mm
3
Set the positions of three push rollers.
Push both ends and center of the media so that it comes over the media
sensor, and set the push rollers so that they comes over the grit rollers.
( ) Move the push rollers, that are not used, to the Standby position. ( )
Push roller
Media
Grit roller
4
Take up the slack of roll media, and fix it with the Push
rollers.
Pull the edge to take up the slack.
If the sheet media is used
1 Lower the media set lever to raise the Push rollers. (See "If
the roll media is used".)
2
Insert the media through the bottom of Push roller. (See "If
the roll media is used".)
When the media width is 100 to 160mm
3
Set the positions of two Push rollers.
Push both ends of media so that it comes over the top of Media sensor,
and position the Push rollers while the left edge of grit roller is being set
as the starting point so that the Push roller come over the lengthy grit
rollers at right edge. ( ) Move the Push rollers, that are not used, to the
Standby position. ( )
Media sensor
Media
Media sensor
Media set lever
Raise the Media set lever.
Lower the Media
lock (Cancel).
The MEDIA FEEDING METHOD
SELECTION screen appears.
Origin point
Push roller
Set the Media and
Push rollers on the
lengthy Grit roller.
Move away the Push
roller that is not used.
Grit roller
Position of Push roller
For the adjustment of Push roller position, see
"Aligning the Push Roller" in FC8600 User's Manual.
P.2-13
Standby position
For the standby position, see "Standby of Push
Roller" in FC8600 User's Manual.
Switching the pressure of push
rollers
When you cut with 3 or more push rollers, switch
the center push roller .Refer to FC8600 user`s
manual.
P.2-13
For front loading
Media lock
Position of Push roller
For the adjustment of Push roller position, see
"Aligning the Push Roller" in FC8600 User's Manual.
P.2-13
Standby position
For the standby position, see "Standby of Push
Roller" in FC8600 User's Manual.
When the media width exceeds
161mm
See "If the roll media is used".
P.2-13
Media
set
lever
P.2-13
19