GRAPHTEC FC8600 SERIES Setup Manual page 20

4
Take up the slack of roll media, and fix it with the Push
rollers. (See "If the roll media is used".)
2.
Set the media type into the Plotter.
Set the media type into the Plotter depending on the preset media.
1
Select the type of the loaded media.
Use the keys numbered [1] to [4] of Control panel to select.
Plot starting with the edge of media.
Roll media
Plot starting with the preset position.
Sheet media
When similar media is reset
Once the media is set, the next screen appears.
2
Wait until the Plotter detects the media size and setting
completes.
Once completed, the next screen appears.
3.
Attaching the Tool
Attach a tool (cutter plunger, plotter pen) to the Plotter. It is explained here using cutter plunger as an example.
1
Loosen the Tool holder screw.
20
The MEDIA FEEDING METHOD
SELECTION screen appears.
"READY" appears.
This screen is called as "Ready status".
To change the loading method
It is set to rear loading in the initial setting. If setup
was made according to Front loading, change the
[1]
loading method. For the change of loading method,
[2]
see "Setting Feeding Method" in FC8600 User's
Manual. P.2-19
[3]
[4]
Display of "CONTINUE"
Depending on the status of Plotter, the fourth option
"CONTINUE" may appear.
To reset the similar media and to continue the same
setting as is during plotting, select the "CONTINUE".
It appears when Media set lever is raised/lowered
after setting the media.
Ready status
The "READY" appears on LCD when PC data
receiving enabling status is achieved in Plotter.
Default screen
When power source of main unit is turned on, the
screen after version displayed is called "DEFAULT
SCREEN".
CAUTION
Do not touch the Tool edge when power is turned on
or during operation.