To Connect Using Usb Cable - GRAPHTEC FC8600 SERIES Setup Manual

3.
Installing the FC8600 Plotter Driver
Once installing of Cutting Plotter Controller is terminated, the
install screen of FC8600 Plotter Driver appears.
1
Operate according to the instruction in the screen.
To connect using the USB cable
2
Select the Interface.
The procedures vary depending on the selected Interfaces.
3
Install the Driver software.
Click the [CHECK BOX].
12
Click the [OK].
Click the [Next].
Click the [Next].
Select "USB" from Pull
down list.
Click the [Next].
Click the [Install].
CAUTION
Do not connect the Interface cable between Plotter
(FC8600) and PC before installing the FC8600
Plotter Driver.
Port name
Select the "Port name" depending on the Interface
that is used.
Interface
To connect using the USB cable
To connect using the Network
cable
To connect using the RS-232C
cable
To output the data for plotting into the
fi le without connecting to the plotter
Port Next
name procedure
USB P.12
TCP/IP P.14
COM1 P.15
FILE -