GRAPHTEC FC8600 SERIES Setup Manual page 17

6.
Installing the User's Manual
1
Click the [Install User's Manual] on the "Start" screen of
Installer.
2
Operate according to the instruction in the displayed
screen.
Setting up the Plotter main unit
1.
Setting the media (paper)
For the FC8600, the roll media and sheet media can be used. The feeding method includes rear loading (feeding
from rear side) and front loading (feeding from front side). Select it depending on the assembled way of Plotter.
If the roll media is used
Explained here is the operation method that is used for rear loading. For use in
front loading, see the column shown at right.
Select the "Install User's
Manual".
Click [Next].
The installed User`s manual is registered in Start menu
of Windows.
Media
The setup methods vary depending on the media
type, width and loading method. See the page
stated in the "Next procedure" of the following
conditions table.
Media
Media width
type
160 to 540mm
Roll
media
540mm or over
100 to 160mm
Sheet
media
160mm or over
Click [Finish].
Loading Next
method procedure
F/R P.18
F/R P.19
F/R P.19
F/R P.19
17