Install The Cowl - GREAT PLANES RV-4 Instruction Manual

❏
3. Cut the instrument panel decal from the decal sheet
and locate the plywood instrument panel. Glue the decal to
the back of the plywood instrument panel. After the glue has
dried, glue the panel into the front of the cockpit.
❏
4. If you will be installing a pilot, do this now. We used a
1/4-scale pilot. Secure the pilot into place using glue or screws.
❏
5. Place the canopy onto the canopy base and trace the
shape of the canopy. Cut a small strip of covering from
inside the lines you have drawn. Glue the canopy to the
canopy base with RC56 canopy glue.
❏
6. Place the completed canopy onto the top of the
fuselage. Secure it to the fuselage with two 8-32 x 1/2"
[13mm] MS and #4 flat washers.

Install the Cowl

❏
1. Locate three 3/4" x 3/4" x 3/4" [19 x 19 x 19mm] hardwood
blocks. Epoxy one block to the top center of the firewall and one
on each side as shown, flush with the sides of the fuse.
21