Omron NB Series Operation Manual page 371

3 Functions of NB-Designer
6
How to know which group of recipe data is the current group? What is used to control the
display of LW0? Later, create another two Multiple State Setting components with address of
LW0 for both of them, and Setting Mode of "Sub value" and "Add value" respectively. And no
graphics is needed. Overlay the component with Setting Mode of "Sub value" on the Multiple
State Setting component created before with the Setting Mode as "Sub value" and the address
being LW9000, and overlay the component with Setting Mode of "Add value" on the Multiple
State Setting component created before with the Setting Mode as "Add value" and the address
being LW9000, then when we retrieve the recipe data, the value of LW0 will vary accordingly,
and it will display the group where the current recipe data locate, as shown below:
3-330 NB-series Programmable Terminals NB-Designer Operation Manual(V106)