Omron NB Series Operation Manual page 149

3 Functions of NB-Designer
2
Switch to the [Moving Component] tab and set the Type, Status Number, the Minimum of X,
Maximum of X, Minimum of Y and Maximum of Y.
Type and Function Tables:
NB-Designer can assign up to 256 kinds of different statuses to the components. When the
totaling Status Number is set to "1", please note that the value included in [Read Address]
should maintain "0", otherwise the component will not be displayed. Statuses 1 to 256
correspond to the internal values of 0 to 255. The position control is as shown below, and its
position is relative to the original position (X-axis and Y-axis represent abscissa and ordinate
respectively.)
Control Mode
Read Information
Read Address
Read Address + 1
Read Address + 2
The types are as follows:
3-108
X
2 words
Status of vector graphics
or bitmap
X-axis displacement
-
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
Y
2 words
Status of vector graphics
or bitmap
Y-axis displacement
-
X & Y
3 words
Status of vector graphics
or bitmap
X-axis displacement
Y-axis displacement