Compaq ProLiant ML330 Maintenance And Service Manual page 72

3-28 Compaq ProLiant ML330 Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1786-Slot 1 Drive
Array Recovery
Needed. The
following SCSI
drive(s) need
Automatic Data
Recovery: SCSI
Port 1: SCSI ID 0
Select F1 to
continue with
recovery of data to
drive. Select F2 to
continue without
recovery of data to
drive.
-Or-
Slot 1 Drive Array
Recovery Needed.
Automatic Data
Recovery
Previously
Aborted! The
following SCSI
drive(s) need
Automatic Data
Recovery: SCSI
Port 1: SCSI ID 0
Select F1 to retry
Automatic Data
Recovery to drive.
Select F2 to
continue without
starting Automatic
Data Recovery
data to drive data
to drive.
continued
Audible Beeps Probable Source of
Problem
None System in Interim
Data Recovery mode.
Data has not yet
been recovered.
Action
Press F1 to allow Automatic Data
Recovery to begin. Data is automatically
restored to drive X once the drive has
been replaced or seems to be working.
-Or-
1. Press F2 for the system to
continue to operate in the Interim
Data Recovery mode.
The "previously aborted" version
of the 1786 POST message
displays if the previous rebuild
attempt was aborted for any
reason.
2. Run Array Diagnostic Utility (ADU)
for more information.
If the replacement drive was
failed, try using another
replacement drive.
-Or-
If rebuild was aborted due to a
read error from another physical
drive in the array, back up all
readable data on the array, run
Diagnostics Surface Analysis, and
then restore your data.
continued