Compaq ProLiant ML330 Maintenance And Service Manual page 59

Table 3-2
POST Error Messages
continued
Error Code Audible Beeps
805-The bootstrap None
processor is not
the lowest
stepping
processor in the
system. This is
unsupported
configuration.
Swap the position
of the processors
on the system
board to correct
this issue.
806-NVRAM has None
been reset
Please power off
the system and
restore SW1.2 to
the default
position. Run BIOS
Setup to set
default values.
System Halted
807-The Setup None
password is
cleared. Please
power off and
restore the clear
password switch
(SW1.1)
Probable Source of Action
Problem
The system has 1.
detected that the
processors in the
2.
system are not the
same stepping and
that the processor in
3.
processor slot 1 has
a lower stepping
than the processor in
4.
processor slot 2. The
processor in
processor slot 2
must have the same
or lower stepping
than the processor in
processor slot 1.
(Processor stepping
is a designation that
reflects the
processor
generation.)
The system 1.
configuration switch
2.
(SW1), position 2 has
been turned on and
the system
configuration data
3.
has been cleared
4.
from CMOS. This
switch must be
5.
returned to the
default off position
6.
for normal operation
and the ability to
save configuration
7.
setup data.
8.
The system must be
reconfigured.
The system board 1.
configuration switch
2.
SW1.1 has been
turned on and the
system configuration
3.
password has been
4.
cleared. SW1.1 must
be returned to the
5.
default off position
for normal operation
and the ability to set
a password with the
BIOS Setup Utility.
Diagnostics and Troubleshooting 3-15
Remove the processor from
processor slot 1.
Remove the processor from
processor slot 2.
Install the processor from
processor slot 1 into processor
slot 2.
Install the remaining processor
into the available processor slot.
Power down the system.
Locate the system configuration
switch (SW1). See Chapter 4 for
instructions.
Return SW1.2 to the off position.
Restart the system.
Press F10 to run the BIOS Setup
Utility and configure the system.
Select the primary operating
system.
Set the date and time.
Complete additional configuration
as needed.
Power down the system.
Locate the system board
configuration switch.
Return SW1.1 to the off position.
Restart the system.
Press F10 and use the BIOS Setup
Utility to set a new password.
continued