Table of Contents
Advertisement
When using a player VTR that supports Dynamic Tracking (DT), you can begin
editing a t a specified initial speed, and then vary the speed during ~ecording by
rotating the search dial The playback speeds which may be set are 0, +31100,
$i1/10,1.115, -112, 21, +1.5, +2, and +3 times normal speed
m
In DT editing, the allowahle playback range and actual playback speeds may vary
for different players. Use the setup menu (SEtUP-18 and SEtUP-19) to set the
maximum playback speed in the forward direction to +2 or +3 times normal speed,
depending on the capabilities of your player.
To perform DT editing with one player
Proceed as follows
a
4
5
1
2,7,6
3
? 8
6
Use other butions a-" controls as necessary
to control the player and recorder
l
l
,
To
perform
DT
edit~ng wilh
one
player
1
With the player search dial in the raised position, press t ~ i e VAR(ENTRY
+
FF)
button.
The player enters variable-speed playback mode. The player direction
indicator (M) starts flashing.
2
Start playback with the player, and rotate the search dial to select the desired
speed.
3
At the scene where you want to set the player IN point, press the ENTRY
button while holding down the player IN and OUT buttons.
The current tape postion is set as the
IN point. The current tape speed is set as
the initial DT playback speed, and the red FROM TO indicator corsesponding
to the DT player begins to flash.
4
Press the DUR(ENTRY
+
TRANS) button
The button starts flashing.
(Coniintied)
Chapter 6 Advanced Editing
Advertisement
Table of Contents
