Table of Contents
Advertisement
Editing Still and Variable-Speed Playback — DT Editing
5 Enter the duration using the EDIT NO./TRANS/DUR buttons (maximum 999
frames).
If you are conducting an open-end edit (without setting the recorder OUT
point), set the duration to 0.
6 Set the recorder edit points.
7 If necessary, conduct a preview.
The player's speed at the IN point will be the DT initial speed. After passing
the IN point, you can rotate the search dial to vary the speed.
8 Press the AUTO EDIT button to execute the edit.
To vary playback speed during an edit, rotate the search dial in the same way as
you do during a preview.
If you want to change the playback speed during editing
Leave the search dial in the initial speed position, set in step 3, until playback
passes the IN point. If you rotate the search dial before beginning a preview or
automatic edit, the playback may be subject to sudden variations in speed.
To set the player IN point precisely in DT editing
Replace steps 2 and 3 of the previous procedure with the following steps.
1 Rotate the search dial to view the playback. At the scene where you want to set
the player IN point, move the search dial to the center position to stop the tape.
2 While pressing the player IN and OUT buttons, press the the ENTRY button.
The initial playback speed is set to 0 times normal speed.
3 Rotate the search dial to select the desired speed.
4 While pressing the ENTRY button, press the AUDIO SPLIT button.
The initial playback speed is changed from 0 times normal speed to the current
playback speed.
To carry out A/B roll DT editing
1 Select a player which supports DT playback as the FROM source or the TO
source, then carry out steps 1 to 5 in the procedure "To perform DT editing
with one player" on page 6-9(E).
When editing the TO source in DT mode, set the duration to 0 if you are
conducting an open-end edit (without setting the recorder OUT point).
2 Depending on whether or not you will carry out DT editing with the other
player as well, proceed as follows.
e If DT editing will not be used with the other player
Set the edit points for the other player.
e If DT editing will be used with the other player
Carry out steps 1 to 5 in the procedure "To perform DT editing with one player'
captors
|||
TIIII
3 Press the TRANS button, turning its indicator on, and set the transition time.
6-10 (E) | Chapter 6 Advanced Editing
Advertisement
Table of Contents
