Table of Contents
Advertisement
Editing Still and Variable-Speed Piayback
-
DT Editing
5
Enter the duration using the EDIT NO ITRANSDUR buttons (maximum 999
frames)
If you are conducting an open-end edit (without setting the recorder OUT
point), set the duration to O
6
Set the recorder edit points
7
If necessary, conduct a preview
The player's speed at the IN point will be the DT initial speed. After passing
the IN point, you can rotate the search dial to vary the speed
8
Press the AUTO EDIT button to execute the edit
To vary playback speed during an edit, rotate the search dial in the same way as
you do during a preview.
Leave the search diai in the initial speed position, set in step 3, until playback
passes the IN point. If you rotate the search dial before beginning a preview or
automatic edit, the playback may be subject to sudden variations in speed.
l o set the piayer
IN
point
precisely
in DT editing
Replace steps 2 and
3
of the previous procedu~e with the following steps.
1
Rotate the search dial to view the playback At the scene where you want to set
the player
IN
point, move the search dial to the center position to stop the tape
2
While pressing the player IN and OUT buttons, press the the ENTRY button.
The initial playback speed is set to O times normal speed.
3
Rotate the search dial to select the desired speed
4
While pressing the ENTRY button, press the AUDIO SPLIT button.
The initial playback speed is changed from O times normal speed to the current
playback speed.
To carry out Al6 rol1 DT editing
1
Select a player which supports DT playback as the FROM sour.ce or the TO
source, then carr.y out steps
1
to
5
in the procedure "To perform DT editing
with one player" on
page
6-9(E).
When editing the SO source in DT mode, set the duration to
O if you are
conducting an open-end edit (without setting the recorder OUT point).
2
Depending on whether or not you will c a ~ y out DT editing with the other
playeras well, proceed as follows.
e
If DT editing will not be used with the other player
Set the edit points fOr the other player.
o
If DT editing will be used with the other player
Carry out steps
1
to
5
in the procedure "Tu petbrm DT editing with one player
."
3
Press the TRANS button, turning its indicator on, and set the transition time
O
6-1
0
(E)
/
Chaplei 6 Advanced Ediling
l
Advertisement
Table of Contents
