Connecting One Monitor; Connecting The Multiple Units With The Lan - Sony BKM-17R Operating Instructions Manual

Connecting One Monitor

NETWORK switch:
Set to PEER TO PEER.
Monitor
SMF-17R20, etc.
LAN (10/100)
connector
BKM-17R (this unit)
NETWORK switch:
Set to PEER TO PEER.
1
Turn off the power switch of the monitor before
connecting the unit.
2
Set the NETWORK switch of the monitor and the
unit to PEER TO PEER.
3
Connect the LAN (10/100) connector of the
monitor and the LAN (10/100) connector of the
unit by using the SMF-17R20 or the cable supplied
with the controller attachment stand such as BKM-
37H, or a 10BASE-T/100BASE-TX straight LAN
cable (shielded-type, optional).
Note
When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
noises.
4
Connect the DC 12V OUT connector of the
monitor and the DC 12V connector of the unit by
using the SMF-17R20 or the cable supplied with the
controller attachment stand such as BKM-37H.
Or connect the output cable of the AC adaptor
LAN (10/100) DC 12V OUT
connector connector
DC 12V connector
supplied with the unit to the DC 12V connector of
the unit.
Connecting the Multiple Units with
the LAN
The unit controls up to 32 monitors. Up to three units
are connected to one monitor in single mode.
Note
The unit cannot control monitors in another
subnetwork.
NETWORK switch: NETWORK switch:
Set to LAN. Set to LAN.
Monitor
LAN (10/100)
connector
Switching hub
(recommended:
with AUTO MDI/
MDI-X function)
LAN (10/100)
connector
BKM-17R (this unit)
NETWORK switch:
Set to LAN.
1
Turn off the power switch of the monitor before
connecting the units.
2
Connect to the network by using a 10BASE-T/
100BASE-TX cable (shielded-type, optional).
Monitor
LAN (10/100)
connector
AC adaptor
(supplied with this
unit)
DC 12V
connector
15
Connections