When Software V1.10 Or Later Version Is Used With The System Connection Mode Via Ethernet Set - Sony HDCU1000 Installation Manual

3-1-3. When software V1.10 or later version is used with the system connection mode via
Ethernet set
Sets the switch S407 (TEST-SW5) on the AT-167 board to ON
DTX-5 Board
CHARACTER : ON
3-2-2. Status Display
VF Display
Camera Status
SD Signal Status
System Status
Diagnosis
System Diag 1
System Diag 2
System Diag 3
Network Diag 1
Network Diag 2
Network Diag 3
AT Board Diag
AVP Board Diag
DTX Board Diag
DRX(Slot 1) Board Diag
DRX(Slot 2) Board Diag
Slot3 Board Diag
Slot4 Board Diag
Slot5 Board Diag
Slot6 Board Diag
SDP Board Diag
Camera Diag
ROM Version
1. To operate the menu of CCU, open the front panel of HDCU1000/1080/1500, and use the CHARACTER switch,
CANCEL/ENTER switch, and +/_ switch on the DTX-5 board.
2. Pressing the CHARACTER switch upward displays the "status display menu" of CCU.
Pressing the +/_ switch upward (+) or downward (_) changes the pages and another screen is displayed. The page
number zero is a blank page with no character.
3. Pressing the CHARACTER switch downward displays CCU-MENU. CCU-MENU consists of the "system menu" , the
"configuration menu" and the "network setting menu".
When the +/_ switch is pressed upward (+) or downward (_) on the CCU-MENU screen, "→" on the screen moves.
Place "→" beside the desired item, and press the CANCEL/ENTER switch downward (ENTER) to move to the menu
you want to select.
To change each item on the CCU-MENU, select the page to be changed, and press the CANCEL/ENTER switch
downward (ENTER) once to confirm the selected page.
Use the +/_ switch to place "→" beside the item you want to change, and press the CANCEL/ENTER switch
downward (ENTER) once to confirm the item.
Use the +/_ switch to configure the setting of the item that has "?" beside it, and press the CANCEL/ENTER switch
downward (ENTER) once to confirm the setting.
4. To cancel the "status display" and the "CCU-MENU" operation, set the CHARACTER switch to OFF.
. IM/HDCU1000 Series
CAM
CHARACTER switch
CHARACTER
DISP
OFF
MENU
CANCEL/ENTER
CANCEL
switch
CCU Menu Page
ENTER
+/_ switch
** CCU-MENU **
SYSTEM OPERATION
CCU CONFIGURATION
NETWORK SETTING
3-3. System Menu
OUTPUT-SELECT S00
GEN-LOCK PHASE S01
MULTI FORMAT S02
OUTPUT FORMAT S03
S04
SD ASPECT
RETURN FORMAT S05
S06
RETURN SETUP
CCU VIDEO
MENU
3-4-2. Configuration Menu
COLOR BAR C00
BAR CHARACTER C01
C02
MONITOR1
C03
MONITOR2
C04
I/F SETUP
MIC/AUDIO
C05
INCOM/PGM C06
S07
C07
PROMPT/TRUNK
VIDEO SETUP C08
VIDEO ADJUST
VIDEO ADJUST2
MENU SETTING
DISPLAY
DATE
3-5. Network Setting Menu
IP ADDR SET N00
ETHER I/F CONF N01
700PTP SETTING N02
NETWORK RESET N03
C09
C10
C11
C12
C13
3-3 (E)