Table of Contents
Advertisement
The following diagram illustrates the flow of an ABB roll editing session,
ípage 4-3fE))
Select the
FROM
and TO sources
(pago 5-4íE))
Set edil points
lpage 5-fi(E))
Set the transition time
(page 5-7(El)
If necessary. confirm and adjust edit points
ípage
4-1
?(E))
II necessary, review Ihe edit
AIB
roil editing
session
Confirm speciai effects before execution
Confirm that necessary settings, including effect selection, have been made
correctly on the switcher or mixer side before executing a preview or an edit.
For steps in the ahove diagram which refer to Chapter 4, note that A/B rol1 editing
differs from cut editing in the following ways.
Confinning and adjusting edit points
Before adjusting or confirming player edit points, it is necessary to select the
FROM or T O source by pressing the PI or
PZ button. The button lights to
indicate the selected source.
Moving an OUT point during a preview
If you wish to move an OUT point backward during a preview, wait until after
the transition. Then, when the player reaches the desired scene, press the
recorder OUT button while holding down the ENTRY button.
e
Moving an OUT point during an edit
If you wisli to move an OUT point backward dunng an edit, wait until after the
transition. Then, when the player reaches tbe desired scene, press the AUTO
EDIT button or press the recorder OUT button wliile holding down the ENTRY
button
Chapter 5 Editing with Two Players
-
Ni3 Rol1 Edits
5-3
(E)
Advertisement
Table of Contents
