Table of Contents
Advertisement
In cut and SYNC rol1 editing, you can increase your editing efficiency by choosing
to preview as soon as you set IN points.
01
you can skip the preview and proceed
immediately to an automatic edit.
This function is not availahle in A/B roll editing.
For »ior.e i~fomiario~z nboltt SYNC roll editirlg, see "Seffi~zg Trarisitio~l Poi~its Dilrirlg
Previeiv or Edirr
-
SYNC Rol1 Edirirzg" (page 6-]_)(E)),
Proceed as follows to use quick editing.
C
Quick edit procedure
1
Search the player and recorder tapes for the scenes where you want to set the
IN points, then freeze the pictures there.
2
Press the PREVIEW button.
The still playback positions are set as the IN points for player and recorder, and
a preview begins. However, if you have already set IN points, the existing
IN
points are not changed.
3
When you reach the scene where you want to set the OUT point, press the
recorder OUT hutton while holding down the ENTRY button.
The recorder OUT point is set About two secondc later, the player and the
recorder stop (unless yoii are editing in assemble mode, in which case the
recorder stops one second after the
IN
point).
4
Press the AUTO EDIT button.
An automatic edit begins.
If you want to skip the preview.
In step 2, press the AUTO EDIT button instead of the PREVIEW button.
The edit begins immediately.
When you reach the scene where you want to stop, press the AUTO EDIT button
again, or press the recorder OUT button while holding down the ENTRY button.
Chapter
6
Advanced Ed~ting
1G3
(E)
Advertisement
Table of Contents
