Table of Contents
Advertisement
Using two synchronized players, you can begin a special effect transition at any
point in the edit.
To perfOrm a SYNC rol1 edit, proceed as f'ollows.
Use other bunons and controls as
necessary to control the playeis and recordei
l
SYNC
rol1 ediling procedure
1
Select the edit mode
2
Press the SYNC (ENTRY
+
AB)
button
The button lights. The green FROM indicator in the souIce selection section
lights.
3
Select the FROM and TO sources
4
Set the edit points for the recorder and the FROM and TO sour.ces.
o
If the FROM and TO sources are VTRs (cor~esponding to the P1 and P2
buttons), you do not need to set their OUT points. The OUT points will be
calculated automatically at the time when you execute the edit or preview.
If the FROM or TO source is an auxiliary source, corresponding to the
AUXl (ENTRY
+
Pl), AUX2 (ENTRY
+
P2) or AUX3 (ENTRY
+
FROM
TO) button, or if the FROM or TO source is being used in DT editing, you do
not need to set the duration.
5
Set the trarisition time.
If a preview is unnecessary, proceed to step 8
6
Execute a preview.
The FROM and T O sources begin to run simultaneously. When the recorder
passes its IN point, the TRANS button begins to flash rapidly and the duration
is shown in the EDIT NO./TRANS/DUR display.
,
6-1
2
(E)
1
Chapter 6 Advanced Edlting
i
1
Advertisement
Table of Contents
