Sensor (Diverter Gate) Static Jam B (To Stacker Bin) - Lexmark X850e Service Manual

288.04 Sensor (diverter gate) static jam B (to stacker bin)

Step Check
1 Check the sensor (diverter gate) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 2.
5. Touch Diverter gate.
Does the display on the operator panel change every
time the sensing area of the above sensor is
interrupted or blocked?
2 Check the sensor (diverter gate) for proper connection.
Is the above component properly connected?
3 Check the motor (entrance/paddle) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Motor Tests.
4. Touch Motor (entrance/paddle).
Does the above component operate properly?
4 Check the motor (entrance/paddle) for proper
connection.
Is the above component properly connected.
5 Perform a print test.
Does the error remain?
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
sensor (diverter connection.
gate).
Go to "Sensor
(diverter gate)
removal" on
page 4-108.
Go to step 5. Go to step 4.
Replace the drive Replace the
motor (entrance/ connection.
paddle).
Go to "Drive
motor
(entrance/
paddle) and belt
(entrance/
paddle)
removal" on
page 4-99.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-116.
Diagnostic information
7500-XXX
2-37