Sensor (Punch Unit Hp) Lag Error - Lexmark X850e Service Manual

Step Check
5 Is the punch unit motor properly connected?
Is the above component properly connected?
6 Perform a POR.
Does the error continue when the power is turned off/on?

984.01 Sensor (punch unit HP) lag error

Step Check
1 Check the punch rack gear by moving it manually.
Does the above component slide back and forth
properly?
2 Check the sensor (punch unit HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Punch and Staple.
5. Touch Punch unit HP.
Does the display on the operator panel change every
time the sensing area of the above sensor is
interrupted or blocked?
3 Is the sensor (punch unit HP) properly connected?
Is the above component properly connected?
4 Check the punch unit motor for proper operation.
1. Enter the Diagnostic Menu.
2. Touch FINISHER TESTS.
3. Touch Punch unit mtr.
4. Touch Forward or Reverse.
Does the above component operate properly?
Yes No
Replace the punch Replace the
unit motor connection.
assembly.
Go to "Punch unit
motor assembly
removal" on
page 4-47.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-116.
Yes No
Go to step 2. Remove
obstructions.
Go to step 4. Go to step 3.
Replace the Replace the
sensor (punch connection.
unit HP).
Go to "Sensor
(punch hole
select), sensor
(punch cam
front), and
sensor (punch
unit HP)
removal" on
page 4-49.
Go to step 6. Go to step 5.
Diagnostic information
7500-XXX
2-59