11. Remove the bracket (C).
12. Release the hook from the upper media exit roll drive gear 20T(D).
13. Remove the upper media exit roll drive gear 20T.
14. Remove the 6 mm bushing.
15. Use a prying tool to remove the e-clip securing the upper media exit roll assembly (F) to the front of the
finisher.
16. Remove the 6 mm bushing (E).
17. Move the upper media exit roll assembly frontward and outward in the direction of the arrow.
F
E
D
Rear
18. Remove the upper media exit roll assembly (F).
Note: When removing the upper media exit roll assembly (F), do not touch the rubber surface.
Replacement notes:
•
Maker sure the flat spot of the upper media exit roll assembly (F) is installed to the rear.
•
When replacing the upper media exit roll assembly (F), do not touch the rubber surface.
B
E-clip
E
Front
7500-XXX
C
F
Repair information
4-105