Technical Specifications - SPHINX Project Twelve Service Manual

SPHINX

5. TECHNICAL SPECIFICATIONS

Bandwidth
Phase response error
Gain (balanced)
( unbalanced)
Minimum Power Output (1 - 20,000 Hz, 1 W = 0
dBW)
Output voltage / current, max.
THD+N (IHF-A)
IMD
S/N ratio (IHF-A)
Slew rate
Common Mode Rejection Ratio
Damping factor
Input
level, nominal
impedance
Supply capacitance
Power consumption
Power transformer, primary
secondary
Temperature protection
Maximum DC-offset
Short circuit protection
Dimensions (h x w x d)
Weight
This unit conforms to the EMC interference regulations issued by the EU and to the CE standards.
This unit complies with safety regulation VDE 0860 and therefore with international safety regulation IEC 65.
Technical specifications may be changed by SPHINX without prior notice if technical developments make this
necessary.
Project Twelve Service Manual
0 - 1.5 MHz (+0/-3 dB)
0 - 203,000 Hz after RF input filter
<1° (0 - 20,000 Hz)
29.5 dB max. (x 29.9)
29.5 dB max. (x 29.9)
>151 W into 8 ohm (21.8 dBW), THD <0.01%
>246 W into 4 ohm (23.9 dBW), THD <0.01%
>340 W into 2 ohm (25.3 dBW), THD <0.01%
36 V / 16 A
<0.006% (100 W into 8 ohm, 1 - 20,000 Hz)
<0.010% ( 70 W into 8 ohm)
>120 dB
>20 V/µs
>30dB @ 100 Hz
>645 @ 10 Hz
>629 @ 100 Hz
>595 @ 1 kHz
>155 @ 10 kHz
XLR balanced / cinch WBT unbalanced
1.25 V (1.9 dBV) / 1.25 V (1.9 dBV)
600 ohm / 20 kohm
26,920 µF total
600 W max. (5 W standby)
230 VAC / 115 VAC
45 VAC / 3,33 A (2x)
70 °C / 158 F
+350 mV and –350 mV
Measured at source resistor R31
68 x 250 x 340 mm
6,5 kg
6