SPHINX Myth 11 Service Manual 1. UNPACKING ............................3 2. CONTACTING THE MANUFACTURER.....................3 3. THE POWER AMP AT A GLANCE ....................4 Front panel..............................4 Rear panel ..............................5 4. OPERATION ............................6 Power on..............................6 Power off..............................6 5. TECHNICAL SPECIFICATIONS......................7 6. ADJUSTMENT PROCEDURES......................8 Bias................................
The Sphinx Myth 11 design 1. UNPACKING This service manual will help you to optimally Before leaving the factory every Myth 11 is service and repair the Sphinx Myth 11 Stereo subjected to stringent and extensive technical and Power Amplifier. exterior quality inspection.
SPHINX Myth 11 Service Manual 3. THE POWER AMP AT A GLANCE Front panel PROTECT STANDBY POWER STANDBY: To switch the component on and off. STANDBY LED: Indicates the selected function: stand-by POWER LED: Indicates the selected function: amp on...
CONTROL IN: To connect the optical cable from AC POWER: Connect the power amp to a another Sphinx component like a pre-amp. mains outlet (230 - 240 VAC) and the mains INPUT: To connect the cinch cables from the power switch.
From now on you should switch the power amp on and off with the STANDBY button (1) on the front panel or the STANDBY button of another Sphinx component connected to the optical CONTROL IN jack. This way all circuits will remain at working temperature and the audio quality will be 100 % within 15 minutes after activating.
This unit conforms to the EMC interference regulations issued by the EU and to the CE standards. This unit complies with safety regulation VDE 0860 and therefore with international safety regulation IEC 65. Technical specifications may be changed by SPHINX without prior notice if technical developments make this necessary.
SPHINX Myth 11 Service Manual Offset ADJUSTMENT PROCEDURES The Offset adjustment procedure minimises the DC The Myth 11 only has three parameters for each offset value of the amplifier output. This DC offset is channel (so six in total) that might need adjustment: important when capacitive loads are used, such as electrostatic loudspeakers.
At the moment of writing the Myth 11 has one Please also send (by fax or e-mail) the specific known specific problem. information to the Sphinx International Service If in the future you encounter any problem(s) you Department (see page 3): this info can then be may enter the info in this table.
SPHINX Myth 11 Service Manual 8. DIAGRAMS AND PARTS LISTS The next pages contain the front and rear panel lay- out and a complete set of schematic drawings including the associated parts lists (if applicable). Modificatie tegen brommen. TO RIGHT AMP...
Need help?
Do you have a question about the Myth11 and is the answer not in the manual?
Questions and answers