Using The Bypass Tray - Toshiba e-Studio287cs User Manual

How to Load the Paper

Using the Bypass Tray

Use the bypass tray when you want to print on
plain paper, postcards, envelopes, OHP film,
or labels. The side you want to print on should
be placed face up. After loading the paper,
configure its size, type, and thickness by using
the operator panel.
1
1
Hold the bypass tray on both sides,
and fold it down.
2
3
2
Pull the folded paper support
forward between manual guides.
4
5
3
Pull the paper support out.
6
Bypass Tray
Bypass Tray
Paper Support
4
Adjust the manual guides to fit the
paper width.
5
Press down the back of the bypass
tray.
6
With the side you want to print on
facing up, insert the edge of the
paper into the back of the bypass
tray.
Note
•
Loaded paper should not exceed the [ ] mark on the
manual guide. You can load up to 100 pages at 82g/
m (ream weight 70 kg)
2
7
Push the blue set button.
Note
•
Do not mix papers of different size, type, or
thickness.
•
When adding paper to the bypass tray, take out any
paper already inserted, then add the extra paper and
realign the paper into a tidy stack.
•
Curled or warped postcards or envelopes may cause
misfeeds. Try to use material that is not curled. Any
curl of 2 mm or more should be corrected.
•
Do not place any material on the bypass tray other
than paper for printing. Do not use excessive force
when raising or pushing the bypass tray.
- 64 -
Manual Guide
Bypass Tray
Manual Guide
Set Button
(Blue)