Bypass Tray; Right Side Of The Equipment - Toshiba e-STUDIO5506AC Hardware Troubleshooting Manual

1.TROUBLESHOOTING FOR THE HARDWARE
3 Check that there is no folded/curled paper or overloading, and then close the drawer of the Large
Capacity Feeder.
Be sure that the height of the stacked paper does not exceed the line indicated inside of the side guides.
 Bypass tray
Pull out the paper misfed on the bypass tray and place it again.
1
If a sheet of paper is stained, folded or torn, replace it with a new one.
 Right side of the equipment
Do not touch the fuser unit or the metal portion around it.
Since they are very hot, you could be burned or the shock could cause you to injure your hand in the machine.
 Transport unit
Pushing the lock lever, pull out the duplexing unit from the equipment until it stops.
1
A
Be careful not to touch the slide rails (A in the figure).
This could injure you.
28 Clearing a Paper Misfeed
A