Toshiba e-Studio287cs User Manual page 30

Unpacking and Installing the Machine
(4) Return the document holder to
its original position.
1
Note
•
If the operator panel display continues to show
that the toner needs replacing, check that the
lever of each toner cartridge has been fully
turned in the direction of the arrow.
2
4
Load paper in the drawer cassette.
(1) Open the drawer cassette.
3
4
(2)
Adjust the paper stop and paper
guide to match the paper size.
5
6
Paper Guide
Paper
Guide
Note
•
Squeeze the paper stop to adjust its position.
•
Do not remove the cork that is attached to the
plate.
Paper Stop
Plate
- 30 -
(3) Flex the stack of paper back and
forth a few times. Then, make a
neat stack by straightening its
edges against a level surface.
Note
•
Using paper that is not recommended may
cause the machine to malfunction.
& For details about paper, see
(P.56).
(4)
Load the paper with the side to
be printed on face down.
Mark
Note
•
Load the paper, making sure that it does not
exceed the  mark on the paper guide. (300
pieces at 82g/m2 (ream weight 70 kg))
(5)
Set the paper size dial to match
the size of the paper.
Rotate the paper size dial until
it shows the size of paper
contained in the cassette.
"Supported Paper"
The side to be printed
on should be face down.
Set the direction
of the paper.
Paper Size Dial