Ir Remote Confi Guration - Gefen GTV-AUDDEC-N User Manual

In the event that IR commands from other remote controls interfere with the
supplied IR Remote Control unit, changing the IR Remote Control's IR channel
will fi x the problem. The IR Remote Control unit has a bank of DIP switches used
for setting the IR channel. The DIP switch bank is located underneath the battery
cover.
Corresponding DIP Switch Settings for each IR Channel
IR Channel 0
(default)
ON
1 2
It is important that the IR channel on the Remote Control unit, matches the IR
channel set on the 4x1 HD Switcher w/ Audio Decoding. For example, if both
DIP switches on the IR Remote Control unit are set to IR channel 0 (both DIP
switches down), then the 4x1 HD Switcher w/ Audio Decoding must also be set
to IR channel 0. See page 38 on how to change the IR channel on the 4x1 HD
Switcher w/ Audio Decoding.
IR REMOTE CONFIGURATION
How to Resolve IR Code Confl icts
IR Channel 1
ON
1 1 2 2
11
Le Left: Picture of the
op opened rear battery
compartment of the IR co
rem remote showing the
ex exposed DIP Switch
ba bank between the
battery chambers. ba
IR Channel 2 IR Channel 3
ON
1 2
ON
1 2