Advertisement
Why would I need to change the remote channel?
In some instances, the Mini DVI Switcher may use IR codes that confl ict with other
IR remote control devices. The unit may switch inputs when another brand IR remote
control is used or the RMT-2IR may cause other brand IR controlled devices to
behave unexpectedly.
I am experiencing the issues listed above. What do I do?
In these cases it is recommended to change the IR channel that the RMT-2IR remote
control and the Mini DVI Switcher use. The IR channel is confi gured independently
on the RMT-2IR remote control and the Mini DVI Switcher but the channel selection
must match on both units for proper operation.
How Do I change the Remote Channel?
There are service DIP switches on the RMT-2IR remote control and also inside the
Mini DVI Switcher. Use the diagrams below to locate and change the IR channel to
one that is not the default. Remember that the channel must match on both the unit
and remote control for successful operation.
The IR channel DIP switches for the Mini DVI Switcher are located on an 4 bank DIP switch on the
underside of the unit and covered with a piece of silver colored metallic tape. Locate DIP switches 3 and
4. Once adjustments are complete replace all screws and.
Remote Channel 1:
Default
1 2 3 4
Remote Channel 3:
1 2 3 4
IR CODE CONFIGURATION
RMT-2IR Remote Control
Remove the battery cover on the rear side of the RMT-2IR remote control
to expose the DIP switches.
2 DIP switch bank for IR channel confi guration.
Remote Channel 1:
Default
1
2
Remote Channel 3:
1
2
Mini DVI Switcher
Remote Channel 2:
Remote Channel 4:
6
Remote Channel 2:
1
2
Remote Channel 4:
1
2
1 2 3 4
1 2 3 4
Advertisement
