Adjusting The Horizontal Punch Position - Konica Minolta Bizhub C300 Copy Manual

12
The center stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this
completes the procedure.
9
Use the "Fold & Staple" function to print a another sample copy.
10
Check the print result.
– Check that the stapling position is adjusted to the center of the pa-
per.
– If more adjustment is necessary, repeat steps 1 and 9.
Note
If the angle of the staple must be adjusted, contact your technical repre-
sentative.
For details on adjusting the center folding position, refer to "Adjusting the
center folding position" on page 12-58.
Note
Enter the value by mm using the keypad.
Refer to the conversion rate below.
1 in. = 25.4 mm

Adjusting the horizontal punch position

The horizontal position of punched holes when printing with a Punch setting
can be adjusted for each paper type.
0 Before making any adjustments, use a Punch setting to print a sample
copy. Perform the adjustment while checking the sample that was creat-
ed.
1
Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
"Displaying the Administrator Setting screen" on page 12-47.
2
Touch [1 System Setting].
The System Setting screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
12-62
Utility
C300