Konica Minolta Bizhub C300 Copy Manual page 351

7
4
Touch [Custom Size].
The Custom Size screen appears.
5
Type in the length (X) and width (Y) of the paper.
– Make sure that [X] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side X. (5-1/2 inch to 18 inch)
– Make sure that [Y] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side Y. (3-9/16 inch to 12-1/4 inch)
– Check the illustration in the screen for the sides that are considered
X and Y.
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, refer to "System setting" on page 12-17.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
7-14
Copy paper/originals
C300