Radar Connection - Raymarine A Series Installation And Operation Instructions Manual

4.8 Radar connection

The multifunction display is compatible with
Raymarine Non-HD digital radomes and HD /
SuperHD radar scanners. The scanner is connected
using over SeaTalk hs .
Note:
• New c Series and New e Series displays
(excluding the e7 and e7D) can connect 2
SeaTalk hs / RayNet devices directly to the
display.
• New a Series and the e7 / e7D displays can
connect 1 SeaTalk hs
the display.
The radar is usually connected via a Raymarine
network switch. On smaller systems (with only one
display and no other digital devices) the radar may
be connected to the display directly.
Radar connected using Raymarine network
switch
1
1. Radar scanner.
2. Raymarine network switch.
3. RayNet cable.
4. RayNet radar cable.
5. VCM (Voltage Converter Module) — required
for Open Arrays.
6. Power connection.
Radar cable extension
For longer cable runs a radar power and data digital cable extension is required.
58
/ RayNet device directly to
6
Radar connected directly to the display
1. Radar scanner
2. Multifunction display rear connector panel.
3. RayNet Radar cable.
4. Connection to power supply — Open array
scanners require a VCM (Voltage Converter
Module).
RJ45 SeaTalk
To connect a Radar using an RJ45 SeaTalk
cable additional accessories are required.
1
5
1. RJ45 SeaTalk
2. RayNet to RJ45 SeaTalk
3. SeaTalk hs
1
hs Radar cable connection
2
3
hs Radar cable.
hs adaptor cable.
crossover coupler.
a Series / c Series / e Series
D12253-2
hs radar
D12884-1