Raymarine A Series Installation And Operation Instructions Manual page 358

For details on how to select a target to 'slew to' refer
to the radar and chart sections of your manual.
The thermal camera can also automatically slew to:
• MOB target
• Dangerous AIS target
• Dangerous MARPA target
Options to enable or disable the automatic slew
options are available in the thermal camera
application
Setting the camera's height above sea level
To ensure that the thermal camera's alignment can
be set correctly the height of the camera above sea
level must be set.
From the thermal camera application:
1. Select Menu.
2. Select Camera Set-up.
3. Select Slew Settings.
The Slew settings page is displayed.
4. Select Camera height above sea level.
The Camera height above sea level pop up is
displayed.
5. Adjust the value to the required setting.
Aligning the thermal camera horizontally
If you find that slew to cue objects are consistently
too far left or right on the screen then you can
make fine adjustments to the cameras alignment by
following the steps below.
From the thermal camera application:
1. Select Menu.
2. Select Camera Set-up.
3. Select Align camera.
The Align camera to boat pop up is displayed.
4. Adjust the value to the required setting.
This value will adjust the camera's offset position
to port or starboard.
Aligning the thermal cameras elevation
If you find that slew to cue objects are consistently
too low or high on the screen then you can make fine
adjustments to the cameras alignment by following
the steps below.
From the thermal camera application:
1. Select Menu.
2. Select Camera Set-up.
3. Select Elev Align:.
The Align camera to boat pop up is displayed.
4. Adjust the value to the required setting.
This value will adjust the camera's offset position
to port or starboard.
Enabling / disabling automatic slew to cue
From the thermal camera application:
1. Select Menu.
2. Select Camera Set-up.
358
3. Select Slew Settings.
The Slew settings page is displayed which
includes the following auto slew options:
• Auto Slew to MOB
• Auto Slew to Dangerous AIS target
• Auto Slew to Dangerous MARPA target
4. Select the relevant option.
Selecting an option from the list will switch the
auto slew option for that item On or Off.
a Series / c Series / e Series