Replacing the CMOS battery
v
68
CHAPTER 3: Replacing notebook components
Important
Use only CMOS batteries designed for this Gateway notebook.
Tools you need to complete this task:
Flat-blade driver
Phillips #0 screwdriver
Screws removed during this task:
•
2 blackM2x3 (IEEE 802.11 wireless card)
To replace the CMOS battery:
1
Complete the steps in
2
Remove the optional IEEE 802.11 wireless card by following the instructions in
"Replacing the IEEE 802.11 wireless card" on page
3
Disconnect the old battery from the system board.
•
Lift the old battery off of the system board.
Important
The battery is held in place by double-sided tape.
•
Connect the new battery to the system board, then place the battery on the
system board.
Important
Use double-sided tape to hold the new battery in place.
4
Replace the optional IEEE 802.11 wireless card by following the instructions in
"Replacing the IEEE 802.11 wireless card" on page
- OR -
"Preparing the notebook" on page
Scribe or non-marring tool
57.
65.
65.