Adding Or Replacing Memory Modules - Gateway P-79 Service Manual

Adding or replacing memory modules

58
CHAPTER 3: Replacing notebook components
Important
Use only memory modules designed for this Gateway notebook.
Tools you need to complete this task:
Phillips #0 screwdriver
To add or replace memory modules:
1
Complete the steps in
2
Loosen the memory bay cover screws (these screws cannot be removed).
3
Use the thumb notch to lift the memory bay cover, then remove it. Be careful not
to break off the tabs located on the end of the cover opposite the thumb notch.
"Preparing the notebook" on page 57.