Replacing The Modem Jack/Usb Board - Gateway P-79 Service Manual

Replacing the modem jack/USB board

v
132
CHAPTER 3: Replacing notebook components
Tools you need to complete this task:
Flat-blade driver
Phillips #0 screwdriver
Additional materials you need to complete this task:
•
X-23-7762 thermal grease
Screws removed during this task:
•
2 black M2×3 (IEEE 802.11 wireless card)
•
1 black M2.5×5 (DVD drive)
•
2 black M2.5×3 (Keyboard cover)
•
•
3 black M2.5x3 (Keyboard)
•
2 long black (Keyboard)
•
2 black M2.5×8 (Hinge bottom)
•
2 black M2.5×8 (Hinge top)
•
•
•
3 black M2.5×5 (Palm rest-top)
•
2 black M2×3 (Modem)
•
2 black M2.5×3 (Left speaker)
•
1 black M2.5×3 (Right speaker)
•
2 black M2.5×5 (EMI shield)
•
•
1 black M2.5×5 (Modem jack/USB board)
To replace the modem jack/USB board:
1
Complete the steps in
2
Remove the cooling assembly by following the instructions in
802.11 wireless card" on page
3
If the notebook has wireless networking built in, unplug the wireless antennas by
following the steps in
- OR -
6 black M2.5×8 (LCD front panel)
8 black M2.5×8 (Palm rest-bottom)
6 black M2.5×8 (Palm rest-top)
4 black M2.5×5 (System board)
"Preparing the notebook" on page
65.
"Replacing the IEEE 802.11 wireless card" on page
Scribe or non-marring tool
57.
"Replacing the IEEE
65.